EasyManuals Logo

Roland XV-5080. Quick Start

Roland XV-5080.
56 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #37 background imageLoading...
Page #37 background image
37
Let’s Play Sounds From a Sampler Library
Now let’s try loading a sampler library (such as the optional L-CDX Series)
into the XV-5080 and playing some sounds.
Playing sampler libraries with the XV-5080 requires a SCSI-type CD-ROM
drive, and commercially available SIMMs (memory modules).
* At least 16 MB (32 MB or more recommended) of additional memory is required.
Installing the SIMM (Memory Module)
Loading commercial sampler libraries into the XV-5080 requires installation
of a SIMM memory module. The XV-5080 is equipped with two slots for
SIMMs, allowing you to expand memory capacity by 128 MB (with two 64-
megabyte SIMMs installed).
SIMMs for use with the XV-5080 must match the following
specifications.
Number of pins: 72
Access time: 60 ns or faster
Access protocol: FPM or EDO
Voltage: 5 V
Capacity: 64 MB/32 MB/16 MB (can be mixed)
* Both parity and non-parity are supported.
SIMM Hight: 36 mm or lower
Cautions When Installing SIMM
To avoid the risk of damage to internal components that can be caused
by static electricity, please carefully observe the following whenever you
handle the board.
Before you touch the board, always first grasp a metal object (such as
a water pipe), so you are sure that any static electricity you might have
been carrying has been discharged.
When handling the board, grasp it only by its edges. Avoid touching
any of the electronic components or connectors.
Save the bag in which the board was originally shipped, and put the
board back into it whenever you need to store or transport it.
Use a Philips screwdriver that is suitable for the size of the screw. If an
unsuitable screwdriver is used, the head of the screw may be stripped.
To remove a screw, rotate the screwdriver counter-clockwise. To tighten
the screws, rotate the screwdriver clockwise.
fig.00-042.e
Be careful not to cut your hands on the edges of the opening while
removing the cover.
When adding SIMMs, remove only the specified screws.
The Akai S1000/3000 CD-
ROM sound libraries can
also be loaded. For more on
this, “Chapter 7 Loading
Each Type of Data” in the
Owner’s Manual.
tightenloosen

Table of Contents

Other manuals for Roland XV-5080.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Roland XV-5080. and is the answer not in the manual?

Roland XV-5080. Specifications

General IconGeneral
Polyphony128 voices
Multitimbral Parts32 parts
Display240 x 64 dot backlit LCD
MIDIIn, Out, Thru
Sampling Frequency44.1 kHz
Wave Memory64 MB
EffectsReverb, Chorus
Dimensions482 (W) x 88 (H) mm
Outputs8 x individual (1/4"), stereo mix (1/4"), headphones

Related product manuals