22
Try Out the Sounds
PRESET (Preset Memory)
The PRESET library group contains the sounds that are permanently stored
in the XV-5080’s memory.
EXP (Wave Expansion Board)
Select this group to use the tones stored on wave expansion boards (SRX
Series, SR-JV80 Series; sold separately) inserted in the EXP-A through -H
slots.
To select an installed wave expansion board, press the [A]–[H] button.
The EXP-A through EXP-D slots are for cards from the SR-JV80 Series. The
EXP-E through EXP-H slots are for SRX Series boards.
Playing Sounds Using a MIDI Keyboard
Now, try connecting your MIDI keyboard and playing sounds from the XV-
5080.
Connecting a MIDI Keyboard
Connect the MIDI keyboard as shown in the following.
fig.00-023.e
Setting the MIDI Channels
If you intend to have this unit play when it receives MIDI data sent by an
external MIDI device, you need to have the MIDI channel set to the same
channel on both the sending device (the MIDI keyboard or other device) and
on the XV-5080.
Here, in Patch mode, let’s set both MIDI channels to “1.”
fig.00-024.e_80
It is not possible to select
EXP unless a wave
expansion board is inserted
into the corresponding slot.
XV-5080
MIDI keyboard
MIDI IN
MIDI OUT
Executing Factory Reset
sets the receive channel in
Patch and Rhythm Set
modes to “1.”
To Next Page
Loading...
Need help?
General
