Effectivity 912/914 Series
Edition 1 / Rev. 0
page 53
May 01/2007
d02623
73-00-00
BRP-Rotax
Maintenance Manual
3.5) Assembly of carburetor sockets, carburetor and fuel lines
3.5.1) Carburetors and carburetor sockets
See Figs. 73-44, 73-45 and 76-46.
Attach carburetor socket (1) and new O-ring (3) with two hex. screws
(2) M8x25 with washers.
â—† NOTE: On intake manifolds without an O-ring groove, a gasket
(4) (see Illustrated Parts Catalog) must be fitted.
The screws are locked with LOCTITE 221. Tightening torque 15 Nm
(133 in.lb).
Fit carburetor into carburetor socket, which should be free of grease
and oil, align and fix with hose clamp (5). Tightening torque 2.5 Nm
(22 in.lb).
Check distance of 5 to 6 mm (0.2 in. to 0.24 in.) on allen screw (6) as
this is important to allow free movement of the tension spring (7).
Engage tension spring in the bracket (8) using a suitable tool.
â– CAUTION: To ensure efficient carburetor suspension, a distance
of 40 mm (1.57 in.) between allen screw and engage-
ment latch must be respected.
To Next Page
General
