61
7
Select the All menu to check that the device has been registered.
8
When the device is approved by the server, the schedule registered in the selected group
will be downloaded to the device. The schedule will run after it is downloaded.
―
For further details on how to configure a schedule, refer to the <MagicInfo Lite Server user's
manual>.
―
If a device is deleted from the list of devices approved by the server, the device will reboot
to reset its settings.
Setting the current time
A schedule may not run if the time set on the device is different from the server's current time.
1
Select Device from the side menu bar.
2
Select your device.
3
Select Edit → Setup.
4
Select Time Zone.
―
When connecting to the server for the first time, the time on the product is set using the
GMT time of the region where the server is installed.
―
The time on the product can be changed from the server as shown in step 3.
―
Turning the product off and then on again will restore the time setting on the product to
the last time that was set from the server.
―
For further details on how to manage the time (scheduling, holiday management, etc.), refer
to the <MagicInfo Lite Server user's manual>.
To Next Page
Loading...
Need help?
General
