78
Anynet+ (HDMI-CEC)
Anynet+ (HDMI-CEC)
Anynet+ is a function that enables you to control all connected Samsung devices that support
Anynet+ with your Samsung product remote. The Anynet+ system can be used only with
Samsung devices that have the Anynet+ feature. To be sure your Samsung device has this
feature, check if there is an Anynet+ logo on it.
• Off / On
―
You can only control Anynet+ devices using the product remote control, not the buttons on
the product.
―
The product remote control may not work under certain conditions. If this occurs, reselect
the Anynet+ device.
―
Anynet+ works when the AV device supporting Anynet+ is in the standby or on status.
―
Anynet+ supports up to 12 AV devices in total. Note that you can connect up to 3 devices of
the same type.
Troubleshooting for Anynet+
Problem Possible Solution
Anynet+ does not work. • Check if the device is an Anynet+ device. The Anynet+
system supports Anynet+ devices only.
• Check if the Anynet+ device power cord is properly
connected.
• Check the Anynet+ device’s Video/Audio/HDMI cable
connections.
• Check whether Anynet+ (HDMI-CEC) is set to On in the
System menu.
• Check whether the remote control is Anynet+ compatible.
• Anynet+ doesn’t work in certain situations. (initial setup)
• If you have removed and then reconnected the HDMI cable,
please make sure to search devices again or turn your
product off and on again.
• Check if the Anynet+ function of the Anynet device is set on.
I want to start Anynet+.
• Check if the Anynet+ device is properly connected to the
product and check if the Anynet+ (HDMI-CEC) is set to On in
the System menu.
I want to exit Anynet+.
• Press the SOURCE button on the product remote control
and select a non- Anynet+ device.
The message
“Disconnecting
Anynet+ device ...”
appears on the screen.
• You cannot use the remote control when you are configuring
Anynet+ or switching to a view mode.
• Use the remote control after the product has completed
Anynet+ configuration or has finished switching to Anynet+.
The Anynet+ device
does not play.
• You cannot use the play function when initial setup is in
progress.
To Next Page
Loading...
Need help?
General
