setup
38_
setup
Day & Night
The Day & Night function allows the camera to switch between the
Color and B/W modes.
MODE
AUTO : Operates in Color mode most times, and switches
to B/W mode if a low light level is detected during
nighttime.
COLOR : Operates in Color mode at all times.
B/W : Operates in B/W mode at all times. By using the Burst
On/Off sub menu, burst signals can be retained or
disabled.
Ú
If the camera is in B/W mode and connected to equipment
that requires external sync through burst signals, set the Burst
On/Off option to “On”.
Duration :
The camera’s light sensitivity is adjustable as in the chart
below. The camera’s ambient light diversion performance
may vary depending on its environment.
Color
p
B/W B/W
p
Color
FAST 2.5Lux 4Lux
SLOW 0.8Lux 6Lux
Dwell Time :
The duration of both the lighting conditions can be customized to let
the camera divert between the daytime and nighttime settings.
Auto mode is not available if AGC is set to OFF or MANUAL. Only available if it is set to COLOR or B/W.
Using B/W mode under sunlight or a halogen lamp may decrease the focusing performance.
z
-
-
-
z
-
z
-
M
Main Menu
偓
Camera Setting
#
Sequence Setting
#
P/T Setting
#
OSD Setting
#
Alarm Setting
#
Initialize
#
Status
Æ
Camera Setting
Focus & Zoom
White Balance ATW
Exposure
Back Light OFF
AGC MEDIUM
SSNR MEDIUM
SSDR
偓
Day & Night
Others
Day & Night
偓
Mode AUTO
Duration FAST
Dwell Time 05 SEC
Æ
To Next Page
Loading...
Need help?
General
