44_
setup
setup
IMAGE ADJ
Use this menu to adjust images. After you select this
option, the following sub menu will appear.
3D-DNR (Noise Reduction) :
Press the LEFT button or the RIGHT button to
limit the amount of noise produced. (Default
value: M)
SHARPNESS (Edge Emphasis) :
Use this option to use image processing to
emphasize edges. Press the LEFT button or
RIGHT button while the cursor is aligned with
“2. SHARPNESS” to switch the SHARPNESS
setting from 0-5. Select “5. RETURN” to confi rm
the current setting and go back to the MAIN
SETUP menu screen. (Default value: 4)
ZOOM (Digital Zoom Settings) :
Press the LEFT button or RIGHT button while
the cursor is aligned with “3. D-ZOOM” to switch
the zoom setting from: OFF
X2 (times two)
X4 (times four)
OFF. Select “5. RETURN” to
confi rm the current setting and go back to the MAIN SETUP menu screen. (Default value: OFF)
POLARITY :
Use this option to set the black/white properties of images. When “BW” is selected, high
temperature areas will be shown in white, while low temperature areas will be displayed in black.
If “WB” is chosen, black and white will be displayed in the opposite way as BW. Press the LEFT
button or RIGHT button while the cursor is aligned with “4. POLARITY” to switch the black/white
inversion setting from: BW
WB
BW. Select “7. RETURN” to confi rm the current setting and
go back to the MAIN SETUP menu screen. (Default value: BW)
COLOR :
Use this option to set the color of images. When “COLOR1” is selected, high temperature areas
will be shown in red, while low temperature areas will be displayed in blue. If COLOR2 chosen,
high temperature areas will be shown in yellow, while low temperature areas will be displayed
in blue. When “MONO” is selected, high temperature areas will be shown in white, while low
temperature areas will be displayed in black.
ISOTHERM :
ISOTHERM can apply colors to the area whose temperature range over “L RANGE TH” or “H
RANGE TH” in the screen.
L RANGE TH : Minimum temperature in the ISOTHERM’s area when RANGE is L.
H RANGE TH : Minimum temperature in the ISOTHERM’s area when RANGE is H.
RETURN Confi rm the current setting and go back to the IMAGE ADJ sub menu screen.
z
z
z
z
z
z
MAIN SETUP
1. BRIGHTNESS AUTO
2. CONTRAST MANUAL
3. RANGE AUTO
4. NUC
5. NUC MODE INTERVAL
► 6. IMAGE ADJ
7. SPECIAL
IMAGE ADJ
► 1. 3D-DNR M
2. SHARPNESS 4
3. D-ZOOM OFF
4. POLARITY BW
5. COLOR COLOR1
6. ISOTHERM
OFF
7. RETURN
To Next Page
Loading...
Need help?
General
