Sanyo PID-42NE1 Installation Guidelines

English
Off timer 90
1
2
3
4
10:00
PC
4:3
17
Basic Controls
Remote Control Transmitter
Standby (ON / OFF) button
The Display must rst be plugged into
the wall outlet and turned on at the
power switch (see page 13).
Press this button to turn the Display On,
from Standby mode. Press it again to
turn the Display Off to Standby mode.
ACTION button
Press to make selections.
ASPECT button
Press to adjust the aspect.
Sound mute On / Off
Press this button to mute the
sound.
Press again to reactivate sound.
Sound is also reactivated when
power is turned off or volume level
is changed.
Digital Zoom
OFF TIMER button
The Display can be preset to switch to stand-by
after a xed period. The setting changes to 30
minutes, 60 minutes, 90 minutes and 0 minutes
(off timer cancelled) each time the button is
pressed.
30 60
0
90
When three minutes remain, “Off timer 3” will
ash.
The off timer is cancelled if a power interruption
occurs.
RECALL button
Press the “RECALL” button to display
the current system status.
1
Input label
2
Aspect mode
3
Off timer
The off timer indicator is
displayed only when the off
timer has been set.
4
Clock display
AUTO SETUP button
Automatically adjusts the position/
size of the screen.
N button
POSITION buttons
PICTURE button
INPUT button
Press to select Input signal
sequentially. (see page 15)
POS. /SIZE button
Volume Adjustment
Press the Volume Up “+” or Down “–”
button to increase or decrease the
sound volume level.
R button (see page 18)
Press the R button to return to previous
menu screen.
SET UP button
SOUND button
*
*
* These buttons cannot be operated from the main unit.

Sanyo PID-42NE1 Specifications

General

Brand	Sanyo
Model	PID-42NE1
Category	Monitor
Language	English