SICK DS35 User Manual

8014868/YIF1/2020-10-19 • © SICK AG • Subject to change without notice 13
Safety
2.3 Requirements for skilled persons and operating personnel
WARNING!
Riskofinjuryduetoinsucienttraining!
Improper handling may result in considerable personal
injury and material damage.
For this reason:
• All work must only ever be carried out by the stipulated
persons.
The operating instructions state the following qualication requirements for
the various areas of work:
• Qualiedpersonnel
are able to carry out the work assigned to them and independently
recognize potential risks due to their specialist training, knowledge, and
experience, as well as knowledge of the relevant regulations.
• Electrical specialists
are able to carry out work on electrical systems and independently
recognize potential risks due to their specialist training, knowledge, and
experience, as well as knowledge of the relevant standards and regula-
tions.
The electrician must comply with the provisions of the locally applicable
work safety regulation.
2.4 Warningsymbolonthedevice
Laser class 2 Distance sensors with a class 2 laser according to EN/IEC60825-1:2014
(identical laser class for issue EN/IEC 60825-1:2007) carry the following
warning label.
LASER APERTURE
MAX. OUTPUT ≤ 250mW
PULSE LENGHT = 4ns
WAVELENGHT = 658nm
EN/IEC 60825-1:2014
Complies with 21 CFR
1040.10 and 1040.11
except for deviations
pursuant to laser notice
No. 50, dated June 24, 2007
LASER
2
• Laser output aperture label, →
See Fig. 5 on page 17
• CAUTION LASER RADIATION
Do not look into the beam.
Laser class 2 product
• Specication of maximum output
power, pulse length, wavelength
• EN/IEC 60825-1:2014:
Complies with 21 CFR 1040.10
and 1040.11 except for tolerances
according to Laser Notice No. 50
dated 24/06/2007
Fig. 1: Warning symbol on sensor with class 2 laser

SICK DS35 Specifications

General

Brand	SICK
Model	DS35
Category	Accessories
Language	English