Siemens RUGGEDCOM RX1510 Installation Guide

Chapter 2
Installing the Device
RUGGEDCOM RX1501
Installation Guide
10 Removing a Power Supply
1. Remove the blank power module assembly or, if equipped, the currently installed power supply. For
information about removing a power supply, refer to Section 2.2.1.2, “Removing a Power Supply”.
2. Insert the power supply into the empty slot. When power is supplied to the device, the top and bottom LEDs
on the power supply should be green, indicating that power is being received and supplied to the device.
3
2
1
Figure 6: Installing a Power Supply
1. Chassis 2. Power Supply 3. Screws
3. Hand-tighten the screws to secure the power supply.
Section 2.2.1.2
Removing a Power Supply
To remove a power supply, do the following:
1. Remove the screws that secure the power supply.
2. Pull the power supply from the chassis.
3
2
1
Figure 7: Removing a Power Supply
1. Chassis 2. Power Supply 3. Screws
3. Install the blank power module assembly into the empy slot to prevent the ingress of dust and dirt.

Siemens RUGGEDCOM RX1510 Specifications

General

Brand	Siemens
Model	RUGGEDCOM RX1510
Category	Switch
Language	English