RUGGEDCOM RX1501
Installation Guide
Chapter 3
Communication Ports
Cellular Modem Installation Requirements 27
Figure 44: W12, W22 and W32 Cellular Modems
1. Main Antenna SMA Connector 2. Receive Diversity Antenna
SMA Connector 3. Antenna for First/Primary Cell Modem
Order Code Description
W12 2 Port Cell Modem GSM,EDGE,HSPA+
W22 2 Port Cell Modem EVDO Rev.A Verizon
Wireless
W32 1 Port Cell Modem GSM,EDGE,HSPA+, 1 Port
Cell Modem EVDO Rev.A Verizon Wireless
The following sections describe the cellular modem modules in more detail:
• Section 3.6.1, “Cellular Modem Installation Requirements”
• Section 3.6.2, “Diversity Requirements”
• Section 3.6.3, “Supported Frequency Bands”
• Section 3.6.4, “Installing SIM Cards for GSM, EDGE and HSPA+ Cellular Modems”
Section 3.6.1
Cellular Modem Installation Requirements
The cellular modem module is approved for modular use in mobile applications. The module, as part of the
RX1501, can be integrated into a final product without additional certification from the Federal Communications
Commission (FCC) or Industry Canada (IC) if the application meets the following requirements:
NOTE
If this module is integrated into a portable device, separate approval related to the Specific Absorption
Rate (SAR) requirements of FCC Part 2.1093 and IC RSS-102 is required.
• Persons in the area must be kept at least 20 cm (8 in) from the antenna at all times.
• The antenna gain, including cable loss, must not exceed the maximum rating specified in Section 3.6.3,
“Supported Frequency Bands”.
• The cellular modem and antenna must not be next to or operate in conjunction with another transmitter or
antenna within a host device.
• A label must be affixed to the end product that indicates the FCC and IC IDs for the cellular modem.
Cellular Modem FCC ID IC ID
W11, W12 N7MC8705 2417C-MC8705
W21, W22 N7MC5728 2417C-MC5728
W32 N7MC8705 and N7MC5728 2417C-MC8705 and 2417C-MC5728
• The user documentation for the end product must clearly indicate the operating requirements and conditions
that comply with current FCC and IC radio frequency exposure guidelines.
• The end product must comply with the unintentional emission testing requirements of FCC Part 15.
To Next Page
Loading...
Need help?
General