Siemens RUGGEDCOM RX1510 Installation Guide

Chapter 3
Communication Ports
RUGGEDCOM RX1501
Installation Guide
20 Fiber Optic Ethernet Ports
Pin 10/100Base-Tx Signal
10/100/1000Base-
Tx Signal
8 RX- B-
1 2
3
4
8
7
6 5
Figure 27: 8-Pin M12 X-Coded Ethernet Port Pin
Configuration
Pin 10/100/1000Base-Tx Signal
1 A+
2 A-
3 B+
4 B-
5 D+
6 D-
7 C+
8 C-
Figure 28: 4-Pin M12 D-Coded Ethernet Port Pin
Configuration
Pin 10/100Base-Tx Signal
1 TX+
2 RX+
3 TX-
4 RX-
a
Terminated at GND (Ground)
For specifications on the available copper Ethernet ports, refer to Section 4.4, “Copper Ethernet Port
Specifications”.
Section 3.2
Fiber Optic Ethernet Ports
Fiber optic Ethernet ports are available with either MTRJ (Mechanical Transfer Registered Jack), LC (Lucent
Connector), SC (Standard or Subscriber Connector) or ST (Straight Tip) connectors. Make sure the Transmit (Tx)
and Receive (Rx) connections of each port are properly connected and matched to establish a proper link.
21
Figure 29: MTRJ Port
1. Tx Connector 2. Rx Connector
21
Figure 30: LC Port
1. Tx Connector 2. Rx Connector

Siemens RUGGEDCOM RX1510 Specifications

General

Brand	Siemens
Model	RUGGEDCOM RX1510
Category	Switch
Language	English