Chapter 4
Technical Specifications
RUGGEDCOM RX1501
Installation Guide
42 Operating Environment
Module Operating Temperature Compliance
60 to 75 °C (140 to 167 °F) Reduced Radio Frequency (RF)
performance
-30 to 60 °C (-22 to 140 °F) Full Radio Frequency (RF) complianceW21, W22, W32 (Second Radio)
60 to 75 °C (140 to 167 °F) Reduced Radio Frequency (RF)
performance
Section 4.7
Operating Environment
NOTE
The ambient operating temperature is reduced for devices equipped with a cellular modem. For more
information, refer to Section 4.6, “Cellular Modem Specifications”.
Parameter Range Comments
Ambient Operating Temperature -40 to 85 °C
(-40 to 185 °F)
i
Measured from a 30 cm (12 in) radius surrounding the center of the
enclosure.
Ambient Relative Humidity 5% to 95% Non-condensing
Ambient Storage Temperature -40 to 85 °C
(-40 to 185 °F)
i
Maximum ambient operating temperature is 70 °C (158 °F) when the device is installed along with Underwriter Laboratories (UL) listed devices.
Section 4.8
RUGGEDCOM APE Specifications
Feature APE1402 APE1402W7 APE1404 APE1404W7 APE1404CKP
Processor Intel Atom E660 1.3 GHz, 512 KB L2 Cache Intel Atom E660T 1.3 GHz, 512 KB L2 Cache
RAM 2 GB DDR2, 800 MHz, 32-bit
Disk 8 GB SATA, solid state 16 GB SATA, solid state
Networking Realtek RTL8111, RJ45 Gigabit Ethernet interface
USB 2 x USB 2.0, maximum combined USB device power consumption 500 mA at 5 V
Video Intel 4108 Grpahics Processor, DVI-D
LED Indications Power and Disk
Controls Momentary contact reset button
Temperature Range -40 to 70 °C (-40 to 158 °F)
Power Requirements 12 W with no USB load, 14.5 W with full USB load
Software Platform Debian Linux® Windows®
Embedded Standard
7
Debian Linux® Windows®
Embedded Standard
7
Check Point GAiA™
OS
To Next Page
Loading...
Need help?
General