SIMATIC IPC277G
40 Operating Instructions, 08/2021, A5E50059956-AA
Commissioning the device and device functions
4.1 General information on commissioning
Danger of burns
The surface of the device can reach temperatures of over 65 °C. Any unprotected contact
may cause burns.
Avoid direct contact during operation of the device. Touch the device only with appropriate
Configuring memory cards in the
device
Memory cards used in a device need to be configured on that device. Memory cards
configured on other devices will not boot as the drive parameters will be different.
Requirement
• The device is connected to the power supply.
• The protective conductor is connected.
• The connection cables are plugged in correctly.
• The following hardware is available for initial commissioning:
– One USB keyboard
– One USB mouse
– A monitor/display
4.2 Switching the device on/off
For the configuration with operating system pre-installed, the operating system is set up
automatically on the device after the initial switch-on. The commissioning procedure in this
chapter is only applicable to the IPCs with operating system.
For the configurations without operating system pre-installed, contact the operating system
provider to install the operating system first.
To Next Page
Loading...
Need help?
General
