Siemens SIMATIC NET SCALANCE SC-600 Configuration Manual

Configuring with Web Based Management
4.4 "System" menu
SCALANCE SC-600 Web Based Management (WBM)
208 Configuration Manual, 10/2021, C79000-G8976-C475-03
4.4.15 Fault monitoring
4.4.15.1 Power supply
Settings for monitoring the power supply
Configure whether or not the power supply should be monitored by the messaging
system. With a redundant power supply, configure the monitoring separately for each
individual feed-in line.
A fault is then signaled by the message system when there is no power on one of the
monitored lines (line 1 or line 2) or when the voltage is too low.
Note
You will find the permitted operating voltage limits in the compact operating instructions
of the device.
A fault causes the signaling contact to trigger and the fault LED on the device to light up
and, depending on the configuration, can trigger a trap or an entry in the event log table.
Procedure
1. Click the check box in front of the line name you want to monitor to enable or disable
the monitoring function.
2. Click the "Set Values" button.

Siemens SIMATIC NET SCALANCE SC-600 Specifications

General

Product Series	SC-600
VLAN Support	Yes
VLAN standard	IEEE 802.1Q
QoS Support	Yes
Type of housing	Metal
Product Family	SCALANCE
Product type designation	SCALANCE SC-600
Port Types	Ethernet
Number of 100/1000Base-SFP ports	2
Operating Temperature	-40°C to +60°C
Ambient temperature during operation	-40 ... 60 °C
Ambient temperature during storage	-40 ... 70 °C
Relative humidity during operation	10% to 95% (non-condensing)
Protection class IP	IP30
Power Supply	24 V DC
Mounting Type	DIN rail
MTBF	Varies by model
Certifications	CE, UL, cUL, ATEX, IECEx
Switching Capacity	Varies by model
Throughput	Varies by model
MAC Address Table	Varies by model
Number of VLANs	Varies by model
Max. frame size	Varies by model