Compartment identification
9.2 Hardware and software requirements for compartment identification
SIMOCODE pro
162 System Manual, 05/2019, A5E40507475002A/RS-AD/004
9.2 Hardware and software requirements for compartment identification
Basic unit versions
The compartment identification function is supported by the following basic units:
● SIMOCODE pro S basic units
● SIMOCODE pro V PB basic units as from product version E09, firmware version V3.1
● SIMOCODE pro V MR basic units
● SIMOCODE pro V PN basic units
● SIMOCODE pro V EIP basic units.
Basic units SIMOCODE pro C (3UF7000*) and basic units SIMOCODE pro V (3UF7010*)
to E08, V3.0
These basic units do not support the initialization module and start with the internal
parameters.
Current measuring module required
To operate SIMOCODE pro with an initialization module, a current measuring module or a
current / voltage measuring module must be connected to the basic unit.
Version of the operator panel with display
The compartment identification function is supported by operator panels with display as from
product version *E07*.
To Next Page
Loading...
Need help?
General
