3UF50 compatibility mode
11.3 Diagram of diagnostics data
SIMOCODE pro
System Manual, 05/2019, A5E40507475002A/RS-AD/004
181
11.3 Diagram of diagnostics data
The following table shows the diagnostics data in the 3UF50 compatibility mode:
Table 11- 3 Diagram of the diagnostics data in the 3UF50 compatibility mode
Setup 3UF50 -
Device-specific diagnostics
according to DP standard
SIMOCODE DP
Setup 3UF50 -
Device-specific diagnostics
according to DPV1 SIMOCODE DP
Equivalent in SIMOCODE pro V
Same as 3UF-50 diagnostics
7 0x81
7.1 Event: DP block 10.1 Event: DP block Event - Startup parameter block
7.2 Event: Emergency start 10.2 Event: Emergency start Status - Emergency start
7.3 Event: HW test OK 10.3 Event: HW test OK
• No fault - HW fault basic unit
• No fault - Module fault
• No fault - temporary
components
Warning: Unbalance > 40 %
Warning: Unbalance > 40 %
Status - PLC / PCS (intervened)
8.3 Warning: Sensor short circuit 11.3 Warning: Sensor short circuit Warning - Thermistor short
8.4 Event: Cooling down period active 11.4 Event: Cooling down period active Status - Cooling down period
Status - Test position (TPF)
9.0 Warning: Ground fault 12.0 Warning: Ground fault
• Warning internal ground fault
or
• Warning external ground
fault
Warning: Overload + unbalance
Warning: Overload + unbalance
Warning - Overload + unbalance
9.3 Warning: I1 response level
12.3 Warning: I1 response level overshot Warning - Warning level I >
To Next Page
Loading...
Need help?
General
