WARNING
No objects may be placed on the boot cover, the vehicle occupants could be
endangered if there is sudden braking or the vehicle collides with some-
thing.
CAUTION
■
The maximum permissible load of the luggage compartment cover is 1 kg.
■
When closing the boot lid, jamming and damage to the luggage compartment
cover or the side trim panel can occur if handled in an unprofessional way. The
following guidelines must be observed.
■
The holders
B
on the cover must be resting completely on the pins
C
on
the side panel » Fig. 79.
■
The items which are transported must not exceed the height of the lug-
gage compartment cover in the lower position.
■
The cover must not be jammed in the surrounding seal of the luggage com-
partment lid when it is in the upper position.
■
There must be no object in the gap between the cover in the upper posi-
tion and the rear backrest.
■
After removing the luggage compartment cover, store it in such a way that it
cannot be damaged or soiled.
Note
If the support straps
A
» Fig. 79 are attached to the boot, then the boot cover
will raise when the boot is opened.
“Parking position” of the boot cover
Fig. 80
Parking position of the luggage
compartment cover
Read and observe and on page 80 first.
The boot cover can be stowed behind the seat backrest.
Adjusting
›
Slide the dismantled cover between bolt
A
and contact surface
B
of the
side panel » Fig. 80.
WARNING
When adjusting the “parking position”, the boot cover must be between
the bolt
A
and the rear seat backrest - risk of damaging the rear seat
backrest and the boot cover.
CAUTION
■
Before setting the “parking position” of the luggage compartment cover, the
variable loading floor must be put in the upper or lower position» page 85.
■
If the luggage compartment cover is in the “parking position”, the “parking
position” of the variable loading floor cannot be set » page 87.
Storage compartment in the boot
Fig. 81 Remove the tray cover on the left / right
Read and observe
and on page 80 first.
The side compartment covers can be removed to increase the size of the lug-
gage compartment.
Removing/Inserting
›
Grasp the top part of the cover and remove it in the direction of the ar-
row » Fig. 81.
Insertion takes place in reverse order.
83
Transporting and practical equipment
To Next Page
Loading...
Need help?
General
