S
PANNING
T
REE
A
LGORITHM
C
ONFIGURATION
2-91
Once a stable network topology has been established, all bridges listen for
Hello BPDUs (Bridge Protocol Data Units) transmitted from the Root
Bridge. If a bridge does not get a Hello BPDU after a predefined interval
(Maximum Age), the bridge assumes that the link to the Root Bridge is
down. This bridge will then initiate negotiations with other bridges to
reconfigure the network to reestablish a valid network topology.
RSTP is designed as a general replacement for the slower, legacy STP.
RSTP achieves must faster reconfiguration (i.e., around one tenth of the
time required by STP) by reducing the number of state changes before
active ports start learning, predefining an alternate route that can be used
when a node or port fails, and retaining the forwarding database for ports
insensitive to changes in the tree structure when reconfiguration occurs.
Displaying Global Settings
Command Attributes
• Spanning Tree State – Shows if the switch is enabled to participate
in an STA-compliant network.
• Bridge ID – A unique identifier for this bridge, consisting of the
bridge priority and MAC address (where the address is taken from the
switch system).
• Max Age – The maximum time (in seconds) a device can wait without
receiving a configuration message before attempting to reconfigure.
All device ports (except for designated ports) should receive
configuration messages at regular intervals. Any port that ages out STA
information (provided in the last configuration message) becomes the
designated port for the attached LAN. If it is a root port, a new root
port is selected from among the device ports attached to the network.
(References to “ports” in this section mean “interfaces,” which
includes both ports and trunks.)
To Next Page
Loading...
Need help?
General
