VLAN C
OMMANDS
3-121
vlan database
Use this command to enter VLAN database mode. All commands in this
mode will take effect immediately.
Default Setting
None
Command Mode
Global Configuration
Command Usage
• Use the VLAN database command mode to add, change, and delete
VLANs. After finishing configuration changes, you can display the
VLAN settings by entering the show vlan command.
•Use the interface vlan command mode to define the port
membership mode and add or remove ports from a VLAN. The results
of these commands are written to the running-configuration file, and
you can display this file by entering the show running-config
command.
Example
Related Commands
show vlan (3-131)
show interfaces
status vlan
Displays status for the specified VLAN
interface
NE,
PE
3-95
show interfaces
switchport
Displays the administrative and operational
status of an interface
NE,
PE
3-98
Console(config)#vlan database
Console(config-vlan)#
Command Function Mode Page
To Next Page
Loading...
Need help?
General
