C
OMMAND
L
INE
I
NTERFACE
3-184
Default Setting
None
Command Mode
MAC ACL
Command Usage
• New rules are added to the end of the list.
•The ethertype option can only be used to filter Ethernet II formatted
packets.
• A detailed listing of Ethernet protocol types can be found in RFC 1060.
A few of the more common types include the following:
- 0800 - IP
- 0806 - ARP
- 8137 - IPX
Example
This rule permits packets from any source MAC address to the destination
address 00-e0-29-94-34-de where the Ethernet type is 0800.
Related Commands
access-list mac (3-183)
mac access-group
Use this command to bind ports to a MAC ACL. Use the no form to
remove the ports.
Syntax
mac access-group acl_name in
acl_name – Name of the ACL. (Maximum length: 16 characters)
Default Setting
None
Console(config-mac-acl)#permit any host 00-e0-29-94-34-de ethertype 0800
Console(config-mac-acl)#
To Next Page
Loading...
Need help?
General
