M
ULTICAST
F
ILTERING
C
OMMANDS
3-213
Command Mode
Global Configuration
Command Usage
The switch must use IGMPv2 for this command to take effect.
Example
The following shows how to configure the default timeout to 300 seconds:
Related Commands
ip igmp snooping version (3-208)
ip igmp snooping vlan mrouter
Use this command to statically configure a multicast router port. Use the
no form to remove the configuration.
Syntax
ip igmp snooping vlan vlan-id mrouter interface
no ip igmp snooping vlan vlan-id mrouter interface
• vlan-id - VLAN ID (Range: 1-4094)
• interface
• ethernet unit/port
- unit - This is device 1.
- port - Port number.
• port-channel channel-id (Range: 1-6)
Default Setting
No static multicast router ports are configured.
Command Mode
Global Configuration
Console(config)#ip igmp snooping query-time-out 300
Console(config)#
To Next Page
Loading...
Need help?
General
