SMC Networks 6724AL2 User Manual

S ECURE S HELL C OMMANDS
3-49
station clients, and ensures that data traveling over the network arrives
unaltered.
This section describes the commands used to configure the SSH server.
However, note that you also need to install a SSH client on the
management station when using this protocol to configure the switch.
Note:The switch supports only SSH Version 1.5.
ip ssh server
Use this command to enable the Secure Shell (SSH) server on this switch.
Use the no form to disable this service.
Syntax
[no] ip ssh server
Default Setting
Disabled
Command Mode
Global Configuration
Command Usage
• The SSH server supports up to four client sessions. The maximum
number of client sessions includes both current Telnet sessions and
SSH sessions.
Command Function Mode Page
ip ssh server Enables the SSH server on the switch GC 3-49
ip ssh Specifies the authentication timeout for the SSH
server and the number of retries allowed by a
client
GC 3-50
show ip ssh Displays the status of the SSH server and the
configured values for authentication timeout and
retries
PE 3-51
disconnect ssh Terminates an SSH connection PE 3-51
show ssh Displays the status of current SSH sessions PE 3-52

SMC Networks 6724AL2 Specifications

General

Brand	SMC Networks
Model	6724AL2
Category	Switch
Language	English