SMC Networks 6724AL2 User Manual

C OMMAND L INE I NTERFACE
3-212
Command Usage
• The switch must be using IGMPv2 for this command to take effect.
• This command defines the time after a query, during which a response
is expected from a multicast client. If a querier has sent a number of
queries defined by the ip igmp snooping query-count, but a
client has not responded, a countdown timer is started using an initial
value set by this command. If the countdown finishes, and the client
still has not responded, then that client is considered to have left the
multicast group.
Example
The following shows how to configure the maximum response time to
20 seconds:
Related Commands
ip igmp snooping version (3-208)
ip igmp snooping query-max-response-time (3-212)
ip igmp snooping router-port-expire-time
Use this command to configure the query timeout. Use the no form of this
command to restore the default.
Syntax
ip igmp snooping router-port-expire-time seconds
no ip igmp snooping router-port-expire-time
seconds - The time the switch waits after the previous querier stops
before it considers the router port (i.e., the interface which had
been receiving query packets) to have expired.
(Range: 300-500)
Default Setting
300 seconds
Console(config)#ip igmp snooping query-max-response-time 20
Console(config)#

SMC Networks 6724AL2 Specifications

General

Brand	SMC Networks
Model	6724AL2
Category	Switch
Language	English