S
YSTEM
L
OGS
C
ONFIGURATION
2-21
Remote Logs Configuration
The Remote Logs page allows you to configure the logging of messages
that are sent to syslog servers or other management stations. You can also
limit the error messages sent to only those messages of a specified level.
Command Attributes
• Remote Log Status – Enables/disables the logging of debug or
error messages to the remote logging process. (Default: enabled)
• Logging Facility – Sets the facility type for remote logging of syslog
messages. There are eight facility types specified by values of 16 to 23.
The facility type is used by the syslog server to dispatch log messages
to an appropriate service. (Default: 23)
• Logging Trap – Limits log messages that are sent to the remote
syslog server for all levels up to the specified level. For example, if level
3 is specified, all messages from level 0 to level 3 will be sent to the
remote server. (Default: 3)
• Host IP List – Displays the list of remote server IP addresses that
receive the syslog messages. The maximum number of host IP
addresses allowed is five.
• Host IP Address – Specifies a new server IP address to add to the
Host IP List.
To Next Page
Loading...
Need help?
General
