SMC Networks 6724AL2 - Command Line Processing

E NTERING C OMMANDS
3-9
• VLAN Configuration - Includes the command to create VLAN
groups.
To enter the Global Configuration mode, enter the command configure
in Privileged Exec mode. The system prompt will change to
“Console(config)#” which gives you access privilege to all Global
Configuration commands.
To enter the other modes, at the configuration prompt type one of the
following commands. Use the exit or end command to return to the
Privileged Exec mode.
For example, you can use the following commands to enter interface
configuration mode, and then return to Privileged Exec mode.
Command Line Processing
Commands are not case sensitive. You can abbreviate commands and
parameters as long as they contain enough letters to differentiate them
from any other currently available commands or parameters. You can use
the Tab key to complete partial commands, or enter a partial command
Console#configure
Console(config)#
Mode Command Prompt Page
Line line {console | vty} Console(config-line)# 3-75
Interface interface {ethernet port | port-
channel id| vlan id}
Console(config-if)# 3-85
VLAN vlan database Console(config-vlan) 3-121
Console(config)#interface ethernet 1/5
.
.
.
Console(config-if)#exit
Console(config)#