C
LASS
OF
S
ERVICE
C
ONFIGURATION
2-141
Web – Click Priority, IP Precedence Priority. Select a port or trunk from
the Interface field. Select an entry from the IP Precedence Priority Table,
enter a value in the Class of Service Value field, and then click Apply.
*Mapping specific values for IP Precedence is implemented as an interface
configuration command, but any changes will apply to the all interfaces on the switch.
CLI – The following example globally enables IP Precedence service on
the switch, maps IP Precedence value 1 to CoS value 0 on port 5, and then
displays all the IP Precedence settings.
*Mapping specific values for IP Precedence is implemented as an interface
configuration command, but any changes will apply to the all interfaces on the switch.
Console(config)#map ip precedence 3-197
Console(config)#interface ethernet 1/5
Console(config-if)#map ip precedence 1 cos 0 3-198
Console(config-if)#end
Console#show map ip precedence ethernet 1/5 3-202
Precedence mapping status: disabled
Port Precedence COS
--------- ---------- ---
Eth 1/ 5 0 0
Eth 1/ 5 1 0
Eth 1/ 5 2 2
Eth 1/ 5 3 3
Eth 1/ 5 4 4
Eth 1/ 5 5 5
Eth 1/ 5 6 6
Eth 1/ 5 7 7
Console#
To Next Page
Loading...
Need help?
General
