C
OMMAND
G
ROUPS
3-11
Line Sets communication parameters for the serial port,
including baud rate and console time-out
3-75
Interface Configures the connection parameters for all
Ethernet ports, aggregated links, and VLANs
3-85
Address Table Configures the address table for filtering specified
addresses, displaying current entries, clearing the
table, or setting the aging time
3-100
Spanning Tree Configures Spanning Tree settings for the switch 3-105
VLANs Configures VLAN settings, and defines port
membership for VLAN groups
3-121
PVLAN Enables or configures private VLANs 3-132
GVRP and
Bridge Extension
Configures GVRP settings that permit automatic
VLAN learning; shows the configuration for bridge
extension MIB
3-139
Mirror Port Mirrors data to another port for analysis without
affecting the data passing through or the
performance of the monitored port
3-145
Link Aggregation Statically groups multiple ports into a single logical
trunk; configures Link Aggregation Control
Protocol for port trunks
3-148
Rate Limiting Controls the maximum rate for traffic transmitted or
received on a port
3-152
Authentication Configures RADIUS and TACACS+ client-server
authentication for logon access and commands for
IEEE 802.1x port access control.
3-155
Access Control Lists Provides filtering for IP frames (based on address,
protocol, TCP/UDP port number or TCP control
code) or non-IP frames (based on MAC address or
Ethernet type)
3-172
Priority Sets port priority for untagged frames, relative
weight for each priority queue, also sets priority for
TCP/UDP traffic types, IP precedence, and DSCP
3-189
Multicast Filtering Configures IGMP multicast filtering, query
parameters, and specifies ports attached to a
multicast router
3-205
Command
Group
Description Page
To Next Page
Loading...
Need help?
General
