MENTOR 12 US SECTION 2: BASIC CONTROL – Page 24 ER’S MANUAL
• Ph xxx.xxx º:
The Ph tag indicates that the value selection made in the
associated setting window is for PHASE ANGLE in degrees, which
corresponds to the level value selected previously, that is, to the source. The
angle is selected with the resolution and number of available digits indicated
in the relative window. The value selection and direction of rotation are
determined by the selections made in CONFIGURATION.
• ON/OFF: This is used to ACTIVATE or DEACTIVATE the source output.
The INACTIVE status (Output disconnected) corresponds with the GREEN
color and the ON legend on the key. This legend indicates the action that
the key will carry out when pressed, NOT ITS STATUS, which is
indicated by its color.
The ACTIVE status (Output connected) corresponds with the RED COLOR
and the OFF legend on the key
• 25 A/ Freq 1:
This button is both indicator and selector.
As indicator, the top line (in this case 25 A) indicates the maximum permitted
level selection (25) with its relative unit (A). The bottom line (in this case Freq.
1) indicates which of the two frequency buses (Freq 1 or Freq 2) it is assigned
to, or if it is assigned as a direct output, in which case DC
appears.
As selector, it permits selecting the frequency bus or direct mode. To do so,
it suffices to press the button and a menu drops down with the three
possibilities. After the desired one has been pressed, the menu closes and it
is selected.
Selection of an output value
A description is given below of the action to be taken to obtain a certain output value
from one or several Mentor sources at the same time. This description is given step by
step, and it can be applied at any time to any value selection on any control screen as
the process is common to all the equipment control programming:
To Next Page
Loading...
Need help?
General
