SECTION 4: CONFIGURATION
Introduction
You can access this software module at any time just by pressing the key marked
“Configuration” on the main menu situated on the right of any screen.
The Mentor 12 is an extraordinarily complete system insofar as the functions it can carry
out are concerned, as it uses different hardware configurations and operating modes.
That is why it requires a program section with which users can determine how they are
going to use it depending on their application.
In some cases, the configuration is associated with settings with respect to their working
method (angle selection limits, their direction of rotation, frequency assumed, etc...).
In other cases, they depend on the device being tested (type of binary inputs or
outputs).
It can also depend on the type of test that is going to be conducted or on the settings of
the relay being tested, determining the number of channels and the associations
between them so that greater signal levels, greater power, etc. are obtained.
The screens that the section is subdivided into are clear enough for the user not to have
any doubts about choosing the one he has to access in each case. Progression through
them is very intuitive so the actual control guides the user to achieve the desired
configuration.
To Next Page
Loading...
Need help?
General
