C
HAPTER
4
| Configuring the Switch
Configuring Power Reduction
– 49 –
PARAMETERS
These parameters are displayed:
LED Intensity Timers
◆ Time – Time at which LED intensity is set.
◆ Intensity – LED intensity (Range: 0-100%, in increments of 10%,
where 0% means off and 100% means full power)
Maintenance
◆ On time at link change – LEDs set at full intensity for a specified
period when a link change occurs. (Default: 10 seconds)
◆ On at errors – LEDs set at full intensity when a link error occurs.
WEB INTERFACE
To configure LED intensity:
1. Click Configuration, Power Reduction, LED.
2. Set LED intensity for any required hour of the day. Click Add Time to set
additional entries.
3. Set the duration of full intensity when a link change occurs.
4. Specify whether or not to use full intensity when a link error occurs.
5. Click Apply.
Figure 8: Configuring LED Power Reduction
To Next Page
Loading...
Need help?
General
