170
C
onnecting your camcorder to a
computer using the USB cable (For
Macintosh users) (DCR-TRV22/TRV33 only)
When connecting to a computer with the USB cable
You must install a USB driver onto a computer in order to connect your camcorder to
the computer’s USB port. The USB driver can be found on the CD-ROM supplied, along
with the application software required for viewing images.
Recommended Macintosh environment
Mac OS 8.5.1/8.6/9.0/9.1/9.2 or Mac OS X (v10.0/v10.1/v10.2) standard installation is
required.
However, note that the update to Mac OS 9.0/9.1 should be used for the following
models.
•iMac with the Mac OS 8.6 standard installation and a slot loading type CD-ROM drive
•iBook or Power Mac G4 with the Mac OS 8.6 standard installation
The USB port must be provided as standard.
QuickTime 3.0 or later must be installed to play back moving pictures.
Notes
•Operations are not guaranteed for the Macintosh environment if you connect two or
more USB equipment to a single computer at the same time, or when using a hub.
•Some equipment may not operate depending on the type of USB equipment that is
used simultaneously.
•Operations are not guaranteed for all the recommended computer environments
mentioned above.
•Macintosh, iMac, iBook, Power Mac and Mac OS, QuickTime are trademarks of Apple
Computer Inc.
•All other product names mentioned herein may be the trademarks or registered
trademarks of their respective companies. Furthermore, “TM” and “®” are not
mentioned in each case in this manual.
To Next Page
Loading...
Need help?
General