70
You can operate camera brightness and fader on the touch panel when looking at the
viewfinder. Turn the LCD panel over and move it back to your camcorder body with
the LCD screen facing out to do this operation.
The POWER switch should be set to or (DCR-TRV22/
TRV33 only).
Operate by touching the panel.
(1) Turn the LCD panel over and move it back to your camcorder body with the
LCD screen facing out, then extend the viewfinder.
(2) Press
OFF. The PANEL OFF indicator appears on the screen.
(3) Press OK. The LCD screen is turned off.
(4) Using the viewfinder, press the LCD screen. EXPOSURE,
OK, ON and
FADER (only when the POWER switch is set to CAMERA) appear.
(5) Press the LCD screen and select a desired item, then press
OK.
EXPOSURE: Adjust the exposure by pressing –/+.
FADER: Press FADER until a desired fader mode appears.
The indicator changes as follows:
FADER t M. FADER t BOUNCE t MONOTONE
(no indicator) T DOT* T WIPE* T OVERLAP*
* DCR-TRV22/TRV33 only
ON: The LCD screen lights up.
To make the buttons on the LCD screen disappear
Press OK.
Using the viewfinder
4
EXPO–
SURE
OK
ON FADER
ON
EXPO–
SURE
OK
When the POWER switch is set
to CAMERA
When the POWER switch is set to
MEMORY (DCR-TRV22/TRV33
only)
Viewfinder
To Next Page
Loading...
Need help?
General