Maintenance
and
precautions
About
the,
di
See page 13 for the details of discs
which you can use with your
camcorder.
•
Recording
on
the
A
side
Place the disc in your camcorder with the
side with the
~
symbol at the center facing
outwards until it clicks.
~
symbol
Notes
on
use
• Hold the disc by its edge while supporting the
center hole lightly. Do not touch the recording
side (the opposite
of
the printed side when using
a single-sided disc).
• Before shooting, be sure to remove dust and
fingerprints from the disc with a soft cloth.
Otherwise you may not be able to record
or
play
normally
in
some situations using that disc.
• When you set the disc in your camcorder, press
firmly until it clicks. When the message
[C:
13:00]
appears on the LCD screen, open
the disc cover and set the disc again.
• Do not attach any adhesive material such as a
sticker on the surface
of
a disc.
If
you do so, the
disc may become unbalanced, and this may
cause a malfunction
of
the disc or your
camcorder.
Use
of
double-sided
discs
Double-sided discs allow you to record both sides
of
a disc.
Place the
~
symbol facing outwards.
Recording is made on the rear side.
• When using a double-sided disc, take care not to
smudge the surface with fingerprints.
• When a double-sided disc
is
used
in
your
camcorder, recording/playback are performed
on that side only. You cannot switch to record
on orplay back the other side with the disc set to
the camcorder. When recording/playback
of
one
side is complete, remove the disc and tum it
over to access the other side.
• Perform the following operations on each side
of
a double-sided disc:
- Finalizing (p. 67)
- Formatting (p. 72)
- Unfinalizing (p. 74)
•
:l:-
e.
e.
-
o
=
l»
=
-
o
..
3
l»
::::
o
=
Continued"
117
To Next Page
Loading...
Need help?
General