MHC-V50/V50D
16
2-7. DAMP BOARD
7 clip, coating
8 clip, coating
9 DAMP board
q; three screws
(+BVTP 3 x 10)
6 four screws (+BVTP 3 x 8)
2 CN2003
(7P)
3 CN2002 (11P)
5 flexible flat cable
(25 core) (CN2004)
qa heatsink (AMP)
Note:
When you install the heatsink (AMP),
spread the compound referring to
“NOTE OF REPLACING THE IC2002
AND IC2003 ON THE DAMP BOARD
AND THE COMPLETE DAMP BOARD”
on servicing notes (page 5).
– Rear view –
clip, coating
front side
DAMP board
:ire VeWWiQJ
clip, coating
front side
DAMP board
:ire VeWWiQJ
1 Remove the wire from clip, coating.
4 Remove the wire from clip, coating.
Note 1:
When installing the
flexible flat cable
, ensure that the
colored line is not slanted after insertion.
colored line
colored line
Insert is straight to the interior. Insert is incline
flexible flat
cable
flexible flat
cable
connectorconnector
OK
NG
Note 2:
When you install the connector, please install them correctly.
There is a possibility that this machine damages when not
correctly installing it.
Insert is shallow
Insert is straight
to the interior.
connector
Insert is incline
connector
connector
connector
connector connector
OK NG NG