19
Getting Started
b Notes
• When attaching a lens, do not press the lens
release button.
• Do not use force when attaching a lens.
Mounting the lens forcibly may result in a
malfunction or damage of the lens mount.
• There may be a gap between the lens and the
lens mount, depending on the lens attached.
This is normal.
z Tips
• When you have changed the lens, it is
recommended to adjust the black balance (p. 34)
before recording. When you adjust the black
balance, make sure that the front lens cap is
attached.
1 While pressing the lens release
button all the way in, turn the lens
counterclockwise until it stops.
• When you remove the lens, make sure that
you hold both of the lens and the camcorder
body.
2 Replace the packaging lid on the
lens and attach the body cap to
the camcorder body.
• Align the mark on the body cap to the
mounting indexes, and turn the cap
clockwise.
• Before you attach caps, remove dust from
them.
b Notes
• When changing the lens, if dust or debris gets
inside the camcorder body and adheres to the
surface of the image sensor (the part that acts as
the film), it may appear on the image, depending
on the shooting conditions. The image sensor is
applied with the anti-dust coating, to prevent
dust from adhering to the image sensor.
However, attach or remove the lens quickly
somewhere away from dusty locations.
• Do not leave the camcorder body with the lens
and body cap removed.
Removing the lens
Mounting indexes (white)
Lens release button
Align the marks.
Continued ,
To Next Page
Loading...
Need help?
General