UM2448 Rev 6 11/49
UM2448 Quick start
48
6 Quick start
This section describes how to start development quickly using the STLINK-V3SET.
Before installing and using the product, accept the Evaluation Product License Agreement
from the www.st.com/epla web page.
The STLINK-V3SET is a stand-alone modular debugging and programming probe for STM8
and STM32 microcontrollers.
• It support protocols SWIM, JTAG, and SWD to communicate with any STM8 or STM32
microcontroller.
• It provides a Virtual COM port interface allowing the host PC to communicate with the
target microcontroller through one UART
• It provides bridge interfaces to several communication protocols allowing, for instance,
the programming of the target through the bootloader.
To start using this board, follow the steps below:
1. Check that all items are available inside the box
(V3S + 3 flat cables + adapter board and its guide).
2. Install/update the IDE/STM32CubeProgrammer to support the STLINK-V3SET
(drivers).
3. Choose a flat cable and connect it between the STLINK-V3SETand the application.
4. Connect a USB Type-A to Micro-B cable between the STLINK-V3SETand the PC.
5. Check that the PWR LED is green and the COM LED is red.
6. Open the development toolchain or STM32CubeProgrammer (STM32CubeProg)
software utility.
For more details, refer to the www.st.com/stlink-v3set website.
To Next Page
Loading...
Need help?
General
