UM2448 Rev 6 41/49
UM2448 B-STLINK-ISOL board extension description
48
13.2.2 Opened casing for access to all connectors
(through MB1440 adapter board) with B-STLINK-ISOL
1. Remove the USB cable from STLINK-V3SET
2. Unscrew the casing bottom cover of the STLINK-V3SET or remove the adapter board
(MB1440)
3. Remove the JP1 jumper from the MB1441 main module and place it on the JP2 header
of the MB1599 board
4. Put the plastic edge in place to guide the B-STLINK-ISOL board connection to the
STLINK-V3SET main module (MB1441)
5. Connect the B-STLINK-ISOL board to the STLINK-V3SET main module (MB1441)
6. [optional] Screw the B-STLINK-ISOL board to ensure good and stable contacts
7. Plug the MB1440 adapter board into the B-STLINK-ISOL board in the same way it was
previously plugged into the STLINK-V3SET main module (MB1441)
To Next Page
Loading...
Need help?
General
