Edition Manual Chapter Page
2008-03-18 Workshop Manual, Stiga Primo 1 General 1
1 General instructions
Contents in this chapter
General
This Workshop Manual is intended for Stiga Primo model 2008.
This Manual do not cover repair instructions for the motor. Regarding the motor, see the
motor manual.
This Manual and its specifications are valid for machines in their original design. In case of
modified or changed machine, i.e. the motor is replaced, the manual accordance is limited.
The manual is divided in the following chapters:
Chapter 1 is this chapter
Chapter 2 Chassis
Chapter 3 Steering
Chapter 4 Belts
Chapter 5 Electrical system
Chapter 5 Cutting deck
1.4 Unpacking and assembly......... 5
1.4.1 Unpacking.............................. 5
1.4.2 Battery ................................... 6
1.4.3 Assembly............................... 7
1.4.4 Final checks........................... 9
1.4.5 General tightening torque ...... 10
1.5 Instructions for use .................. 10
1.6 Raising....................................... 11
1.6.1 Raising back .......................... 11
1.6.2 Raising front........................... 11
1.7 Turning upsidedown................. 12
1.7.1 Preparing ............................... 12
1.7.2 Draining the petrol ................. 12
1.7.3 Seat with its plate................... 12
1.7.4 Motor hood............................. 13
1.7.5 Motor oil................................. 13
1.7.6 Petrol tank.............................. 13
1.7.7 Turning................................... 13
1.7.8 Restoring the machine on its
wheels.................................... 13
1.1 Introduction................................2
1.1.1 Responsibility declaration.......2
1.1.2 How this manual is used ........2
1.2 Safety Precautions ....................2
1.2.1 Before service or maintenance2
1.2.2 Symbols and general
warnings.................................3
1.2.3 Warm parts.............................3
1.2.4 Moving parts...........................3
1.2.5 Lifting and blocking up............3
1.2.6 Cleanliness.............................3
1.2.7 Tightening torque ...................3
1.2.8 Sharp edges...........................3
1.2.9 Replacement parts .................3
1.2.10 Inspection.............................3
1.3 Guarantee...................................4
1.3.1 Guarantee period ...................4
1.3.2 Exeptions................................4
1.3.3 Conditions for validity of the
warranties...............................4
To Next Page
Loading...
Need help?
General
