北米Model "A2600BE-B" EDITED: 2020/ 10/ 1
4) Digital speed screen (Refer to “Digital
Speed Screen” FP208.)
5) Telltale screen (Refer to “Telltale Screen”
FP204.)
6) Select lever/gear position indicator (Re-
fer to “Select Lever/Gear Position Indi-
cator” FP197.)
7) X-MODE indicator (Outback) (Refer to
“X-MODE Indicator (Outback)” FP199.)
SI-DRIVE indicator (if equipped) (Refer
to “SI-DRIVE Indicator Light” FP197.)
8) Odometer (Refer to “Odometer”
FP173.)/Double trip meter (Refer to
“Double Trip Meter” FP174.)
*: For details, refer to the separate EyeSight
Owner’s Manual.
& Basic Operation
s03bn01
Control switches
1)
2)
3)
By operating or of the control
switches, the screens can be changed.
If there are some useful messages, such
as vehicle information, warning informa-
tion, etc., they will interrupt the current
screen, and appear on the display accom-
panied by a beep. If such a screen is
displayed, take proper action according to
the message shown on the screen.
The warning screen will return to the
original screen after a few seconds. While
the
information reminder is shown on
the display, it may be possible to display
the warning screen again. To recall the
message marked with
on the display,
pull the
switch on the steering wheel
toward you.
& Welcome Screen (Opening
Animation) and Good-Bye
(Ending Animation) Screen
s03bn08
Welcome screen and Good-bye screen
are motion graphic displayed on the
combination meter display and center
information display upon entering and
exiting the vehicle.
When the driver’s door is opened and
closed after unlocking the door, the wel-
come screen (opening animation) will
appear on the combination meter display
(color LCD) for approximately 20 seconds.
When the ignition switch is turned to the
“LOCK”/“OFF” position, the combination
meter display (color LCD) gradually turns
off by showing good-bye screen (ending
animation).
NOTE
. The welcome screen and the good-
bye screen may differ in the actual
words and appearance.
. The basic screen will be shown
when the ignition switch is turned to
the “ON” position while the welcome
screen is displayed.
Combination Meter Display (Color LCD)
202
To Next Page
Loading...
Need help?
General
