北米Model "A2600BE-B" EDITED: 2020/ 10/ 1
X-MODE indicator (models with 2 modes)
1) DEEP SNOW/MUD mode indicator
2) SNOW/DIRT mode indicator
To activate or deactivate the X-MODE,
operate the center information display.
Refer to “Car settings” FP220 (11.6-inch
display models) or “Vehicle setting icons”
FP239 (dual 7.0-inch display models).
NOTE
. Even if you try to activate the
X-MODE when the vehicle speed is 12
mph (20 km/h) or more, the X-MODE will
not be activated. At this time, a buzzer
will sound twice.
. If the vehicle speed reaches 25 mph
(40 km/h) or more while the X-MODE is
activated, a buzzer will sound once and
the X-MODE will be deactivated.
. While the engine is running, if any of
the following conditions is met, the
X-MODE will be deactivated. In this
case, it is not possible to activate the
X-MODE.
– The CHECK ENGINE warning
light/malfunction indicator light illu-
minates.
– The AT OIL TEMP warning light
flashes.
– The ABS warning light illumi-
nates.
– The Vehicle Dynamics Control
warning light illuminates.
. If the engine could overheat because
of a temperature increase of the engine
coolant, it may not be possible to
activate the X-MODE. Even while the
X-MODE is activated, the X-MODE will
be deactivated when the engine coolant
temperature increases.
. The Auto Start Stop system will be
stopped while the X-MODE is activated.
Models with 2 modes:
. SNOW/DIRT is suitable for driving
on a snow-covered road where the
points of contact between the tires
and road surface are visible, or for
driving on an unpaved road.
. D.SNOW/MUD is suitable for driving
on a road covered with deep snow
where the points of contact between
the tires and road surface are not
visible, or for driving on a muddy road.
& Hill Descent Control Function
s07bi03
The hill descent control function will be in
standby mode when the X-MODE is
activated and the vehicle speed is less
than approximately 12 mph (20 km/h).
The function will operate when the vehicle
speed is less than approximately 12 mph
(20 km/h) and the accelerator ratio is less
than approximately 10%.
The function will turn off when the vehicle
speed is more than approximately 12 mph
(20 km/h) and the accelerator pedal is
depressed.
CAUTION
The braking power of the hill des-
cent control function may not be
sufficient when strong braking
power is needed (e.g., when towing
a trailer).
X-MODE (Outback)
362
To Next Page
Loading...
Need help?
General
