北米Model "A2600BE-B" EDITED: 2020/ 10/ 1
SUBARU dealer for details. Also, you can
change the setting by operating the center
information display. For details, refer to “Car
settings” FP220 (11.6-inch display models)
or “Vehicle setting icons” FP239 (dual 7.0-
inch display models).
! Sensor for the auto on/off head-
lights
s03ah0101
The sensor is on the instrument panel as
shown in the illustration.
CAUTION
If any object is placed on or near the
sensor, the sensor may not detect
the level of the ambient light cor-
rectly and the auto on/off headlights
may not operate properly.
& High/Low Beam Change
(Dimmer)
s03ah02
1) High beam
2) Low beam
While the light control switch is in the “ ”,
“
”, or “ ” position in a dark place, the
headlights will turn on.
When the headlights are on high beam, the
high beam indicator light “
” on the
combination meter is also on.
NOTE
While the light control switch is in the
“
” position and the lever is the high
beam position, the high beam assist
function will be on standby.
& Headlight Flasher
s03ah03
CAUTION
Do not hold the lever in the flashing
position for more than just a few
seconds.
To flash the headlights, pull the lever
toward you and then release it. The high
beam will stay on for as long as you hold
Light Control Switch
250
To Next Page
Loading...
Need help?
General
