北米Model "A2600BE-B" EDITED: 2020/ 10/ 1
& Locking and Unlocking
s09ap01
1) Release button
2) Emergency key
While pressing the release button of the
access key fob, take out the emergency
key.
Lock or unlock the driver’s door with the
emergency key in the procedure described
in “Locking and Unlocking from the Out-
side” FP137.
NOTE
After locking or unlocking, be sure to
attach the emergency key back to the
access key fob.
& Switching Power Status
s09ap02
1. Apply the parking brake.
2. Shift the select lever into the “P”
position.
3. Depress the brake pedal.
4. Hold the access key fob with the
buttons facing you, and touch the push-
button ignition switch with it.
When the communication between the
access key fob and the vehicle is com-
pleted, a chime (ding) will sound. At the
same time, the status of the push-button
ignition switch changes to either of the
following.
. When the keyless access with push-
button start system is deactivated:
“ACC”
. Under other conditions: “ON”
5. When the keyless access with push-
button start system is deactivated, press
the push-button ignition switch with the
brake pedal released. The status of the
push-button ignition switch then changes
to “ON”.
NOTE
If the power does not switch even
though the above procedure was fol-
lowed precisely, contact your SUBARU
dealer.
& Starting Engine
s09ap03
1. Apply the parking brake.
2. Shift the select lever into the “P”
position.
3. Depress the brake pedal.
Access Key Fob – If Access Key Fob Does Not Operate Properly
466
To Next Page
Loading...
Need help?
General
