Suzuki DL650K5 User Manual

8-30 ELECTRICAL SYSTEM
INSPECTION
LED (LIGHT EMITTING DIODE)
Check that the LED lights immediately after turning the ignition switch on.
If the LED fails in operation, replace the combination meter unit with a new one after checking its wire har-
ness/coupler.
STEPPING MOTOR
Check that the pointer calibrates itself immediately after turning the ignition switch on and stops at starting
point.
If abnormal condition is found, replace the combination meter unit with a new one after checking its wire har-
ness/coupler.
NOTE:
The pointer may not return to the proper position even turning the ignition switch on under low temperature
condition. In that case, you can reset the pointer to the proper position by following the instruction below:
1)
With the ADJ switch

A
pressed, turn the ignition switch on.
2) Keep pushing the ADJ switch

A
for 3 to 5 seconds.
3) Push the ADJ switch

A
twice (within 1 second).
→
Reset
* Complete the operation within 10 seconds after the ignition switch has been turned on.
Pointer will return to the starting point right after the completion of the operation. In the case of the pointer
not returning to the proper position after doing above, replace the combination meter unit.
ADJ SWITCH
Time Ignition switch ADJ switch
OFF
ON
0
•
•
3 sec
5 sec
•
•
•
•
•
10 sec
PUSH
Release
Push
Push → Reset
PartShark.com
877-999-5686

Suzuki DL650K5 Specifications

General

Brand	Suzuki
Model	DL650K5
Category	Motorcycle
Language	English