Suzuki DR650SE User Manual

3-47 ENGINE
GEARSHIFT SHAFT
• Fit a spring to the gearshift shaft correctly.
• Install the gearshift shaft. Match the center teeth of the
gear on the gearshift shaft with the center teeth on the
cam driven gear as shown.
NOTE:
When replacing the gearshift arm stopper G), apply a small
quantity of THREAD LOCK SUPER "1303" to its threaded
part and tighten it to the specified torque. (See page 7-24.)
~ 99000-32030: THREAD LOCK SUPER "1303"
• Fit the dowel pins @ and new gasket.
• Fit the gearshift cover and tighten the bolts diagonally.
NOTE:
After the gearshift cover and gearshift lever have been fit-
ted, confirm that gear change is normal while turning the
countershaft and driveshaft. If gear change is not obtained,
it means that assembly of gears or installation of gearshift
fork is incorrect. If this is the case, disassemble and trace
the mistake.
NEUTRAL POSITION INDICATOR SWITCH
• Install the neutral position indicator switch spring @ and
switch contact @.
• Install the neutral position indicator switch with two
screws.
• Install the breather cover.

Suzuki DR650SE Specifications

General

Brand	Suzuki
Model	DR650SE
Category	Motorcycle
Language	English