Suzuki Katana 1100 User Manual

7-7 CHASSIS
• Remove both brake discs off the front wheel by removing the
mounting bolts.
INSPECTION AND DISASSEMBLY
TIRE Refer to page 7-36.
WHEEL BEARINGS
Inspect the play of the wheel bearing inner race by hand while
it is in the wheel. Rotate the inner race by hand to inspect for
abnormal noise and smooth rotation. Replace the bearing if
there is anything unusual.
AXLE SHAFT
Using a dial gauge, check the axle shaft for runout and replace
it if the runout exceeds the limit.
09900-20606: Dial gauge (1/100)
09900-20701: Magnetic stand (Not available in U.S.)
Service Limit: 0.25 mm (0.010 in)
l
WHEEL
Make sure that the wheel runout checked as shown does not
exceed the service limit. An excessive runout is usually due to
worn or loose wheel bearings and can be reduced by replacing
the bearings. If bearing replacement fails to reduce the runout,
replace the wheel.
Service Limit (Axial and Radial): 2.0 mm (0.08 in)
• Drive out the both wheel bearings by using the special tool
in the following procedures.
09941-50110: Bearing remover
L _

Suzuki Katana 1100 Specifications

General

Brand	Suzuki
Model	Katana 1100
Category	Motorcycle
Language	English