Suzuki Katana 1100 User Manual

6-5 ELECTRICAL SYSTEM
Ie REGULATOR
Use a variable DC power source, switch and bulb to check the IC regulator, which requires two steps
described below:
First check:
Set the variable DC power source to the 12 V, turn the switch ON position. If the bulb does not light, replace
the IC regulator. If the bulb is lighting on, this IC regulator has passed the first check.
Second check:
Under the above condition, set the variable DC power source to the 14.5 V, if the bulb goes out, IC regulator
is in good condition. If the bulb remains lit, replace the IC regulator.
F
Switch
Pocket tester
(Tester range:
DC25V)
Variable
DC power
source
E
IC regulator
F: Rotor coil terminal
IG: Ignition terminal
E: Ground
GENERATOR DRIVEN GEAR DAMPER
Inspect the dampers for wear and damage. If any defects are
found, replace the dampers as a set.
NOTE:
When installing the dampers, apply Moly Paste to the damper
surface.
99000-25140: SUZUKI Moly Paste

Suzuki Katana 1100 Specifications

General

Brand	Suzuki
Model	Katana 1100
Category	Motorcycle
Language	English