Suzuki Katana 1100 User Manual

EIIIGINE 3-20
ENGINE COMPONENTS INSPECTION AND SERVICING
CYLINDER HEAD SERVICING
CAUTION:
Be sure to identify each removed part as to its location, and
lay the parts out in groups designated as "No.1", "No.2",
"Exhaust", "Inlet", so that each will be restored to the
original location during assembly.
NOTE:
* When removing rocker arm shaft, remove the rocker arm
shaft set bolt (i) and plug @} and screw 8 mm bolt into the
rocker arm shaft end and pull it out.
* Tighten the set bolt (i) and plug @ to the specified torque.
* Removal of valves completes ordinary disassembling work.
If valve guides have to be removed for replacement after
inspecting related parts, carry out the steps shown in valve
guide servicing.
Tightening torque
Set bolt (i): 8 - 12 N·m (0.8 - 1.2 kg-m, 6.0 - 8.5 Ib-ft)
Plug@ : 25 - 30 N·m (2.5 - 3.0 kg-m, 18.0 - 21.5 Ib-ft)
• Using special tools, compress the valve springs and take off
the two cotter halves (i) from valve stem.
09916-14510: Valve lifter
09916-14910: Valve lifter attachment
09916-84510: Tweezers
• Take out the spring retainer, inner and outer springs.
• Pullout the valve from the other side.

Suzuki Katana 1100 Specifications

General

Brand	Suzuki
Model	Katana 1100
Category	Motorcycle
Language	English