Suzuki RM-Z450 Service Manual

12-23 FI SYSTEM DIAGNOSIS
DTC AND DEFECTIVE CONDITION
DTC No.
DETECTED
ITEM
DETECTED FAILURE CONDITION CHECK FOR
12 CKP sensor
The signal does not reach ECM for 1
sec. or more, after receiving the IAP
sensor input signal.
CKP sensor wiring and mechan-
ical parts
CKP sensor, lead wire/coupler
connection
14 TP sensor
The sensor should produce following
voltage.
0.5 V sensor voltage < 4.8 V
In other than the above range, 14 is
indicated.
TP sensor, lead wire/coupler
connection
15 ECT sensor
The sensor voltage should be the fol-
lowing.
0.1 V sensor voltage < 4.8 V
In other than the above range, 15 is
indicated.
ECT sensor, lead wire/coupler
connection
17 IAP sensor
The sensor should produce following
voltage.
0.5 V sensor voltage < 4.4 V
In other than the above range, 17 is
indicated.
IAP sensor, lead wire/coupler
connection
21 IAT sensor
The sensor voltage should be the fol-
lowing.
0.2 V sensor voltage < 4.8 V
In other than the above range, 21 is
indicated.
IAT sensor, lead wire/coupler
connection
23 TO sensor
The sensor voltage should be the fol-
lowing for 5 sec. and more.
0.2 V sensor voltage < 4.6 V
In other than the above value, 23 is
indicated.
TO sensor, lead wire/coupler
connection
24
Ignition sig-
nal
CKP sensor (pick-up coil) signal is pro-
duced, but signal from ignition coil is
interrupted 5 times or more continu-
ously. In this case, the code 24 is indi-
cated.
Ignition coil, wiring/coupler con-
nection, power supply from the
battery

Suzuki RM-Z450 Specifications

General

Brand	Suzuki
Model	RM-Z450
Category	Motorcycle
Language	English