FUEL SYSTEM AND THROTTLE BODY 13-14
• Apply thin coat of the engine oil to the new O-ring.
• Install the fuel delivery pipe
4 to the fuel pipe
5.
• Tighten the fuel delivery pipe mounting screws to the speci-
fied torque.
$ Fuel delivery pipe mounting screw:
3.5 N·m (0.35 kgf-m, 2.5 lb-ft)
• With the throttle valve fully closed, install the TP sensor
6
and tighten the TP sensor mounting screw to the specified
torque.
NOTE:
* Apply thin coat of the engine oil to the O-ring.
* Align the throttle shaft end
C with the groove
D of TP sensor.
* Apply grease to the throttle shaft end
C if necessary.
# 99000-25010: SUZUKI SUPER GREASE “A”
or equivalent
% 09930-11950: Torx wrench (T25)
$ TP sensor mounting screw: 3.5 N·m (0.35 kgf-m, 2.5 lb-ft)
NOTE:
* Make sure the throttle valve open or close smoothly.
* TP sensor setting procedure. ("12-18)
• Connect the Yellow button
E side of the fuel hose to the throt-
tle body side.
• Install the starter knob/idle screw
7 to the lower hole.
CAUTION
Replace the O-ring with a new one.
Never turn the fuel delivery pipe while pushing it.
CAUTION
Replace the O-ring with a new one.
CAUTION
Be sure to connect the fuel hose by your hand. You
may not connect the fuel hose with any tool.
To Next Page
Loading...
Need help?
General
